Wilwood Dynapro 6 Big Brake Front Brake Kit (Hat) User Manual download pdf

ASSEMBLY INSTRUCTIONS

FOR

DYNAPRO 6 FRONT HAT KIT

WITH 12.88” DIAMETER VENTED ROTOR

FACTORY FIVE ROADSTER/CHALLENGE WITH SN95 SPINDLE

PART NUMBER GROUP

140-12048

NOTE: Some cleaners may stain or remove the finish on brake system components. Test the cleaner on a hidden portion

of the component before general use.

WARNING

IT IS THE RESPONSIBILITY OF THE PERSON INSTALLING ANY BRAKE COMPONENT OR KIT TO DETERMINE THE SUITABILITY OF THE

COMPONENT OR KIT FOR THAT PARTICULAR APPLICATION. IF YOU ARE NOT SURE HOW TO SAFELY USE THIS BRAKE COMPONENT OR

KIT, YOU SHOULD NOT INSTALL OR USE IT. DO NOT ASSUME ANYTHING. IMPROPERLY INSTALLED OR MAINTAINED BRAKES ARE

DANGEROUS. IF YOU ARE NOT SURE, GET HELP OR RETURN THE PRODUCT. YOU MAY OBTAIN ADDITIONAL INFORMATION AND

TECHNICAL SUPPORT BY CALLING WILWOOD AT (805) 388-1188, OR VISIT OUR WEB SITE AT WWW.WILWOOD.COM. USE OF WILWOOD

TECHNICAL SUPPORT DOES NOT GUARANTEE PROPER INSTALLATION. YOU, OR THE PERSON WHO DOES THE INSTALLATION MUST

KNOW HOW TO PROPERLY USE THIS PRODUCT. IT IS NOT POSSIBLE OVER THE PHONE TO UNDERSTAND OR FORESEE ALL THE ISSUES

THAT MIGHT ARISE IN YOUR INSTALLATION.

RACING EQUIPMENT AND BRAKES MUST BE MAINTAINED AND SHOULD BE CHECKED REGULARLY FOR FATIGUE, DAMAGE, AND WEAR.

WARNING

DO NOT OPERATE ANY VEHICLE ON UNTESTED BRAKES!

SEE MINIMUM TEST PROCEDURE WITHIN

ALWAYS UTILIZE SAFETY RESTRAINT SYSTEMS AND ALL OTHER AVAILABLE SAFETY EQUIPMENT WHILE OPERATING THE VEHICLE

IMPORTANT • READ THE DISCLAIMER OF WARRANTY INCLUDED IN THE KIT

www.wilwood.com

DISC BRAKES SHOULD ONLY BE INSTALLED BY SOMEONE

EXPERIENCED AND COMPETENT IN THE INSTALLATION AND

MAINTENANCE OF DISC BRAKES

READ ALL WARNINGS

Need Additional Information?

Use Your SmartPhone and

Jump to Our Technical Tips

Section on Our Web Site.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - READ ALL WARNINGS

ASSEMBLY INSTRUCTIONSFORDYNAPRO 6 FRONT HAT KITWITH 12.88” DIAMETER VENTED ROTORFACTORY FIVE ROADSTER/CHALLENGE WITH SN95 SPINDLEPART NUMBER GROUP140-

Page 2 - Photographic Tip

Exploded Assembly Diagram871213103211915141456SRP DRILLED / SLOTTEDPATTERN ROTORGT SLOT PATTERN ROTORRIGHT HAND SIDE SHOWN6 PISTONFigure 1. Typical I

Page 3 - Parts List

Parts List123455A67899A10111213141516244222224242244412121250-12051230-10646240-0476300-11337160-7597/98160-8006/07-BK170-12050240-11240230-8037120-10

Page 4 - Assembly Instructions

Assembly Instructions (numbers in parenthesis refer to the parts list and Figure 1 on the preceding pages):•Orient the caliper mount bracket (1) as sh

Page 5

Assembly Instructions (Continued)•NOTE: OEM rubber brake hoses generally cannot be adapted to Wilwood calipers. The caliper inlet fitting is a 1/8-27

Page 6

Page 6Additional Information and Recommendations•Fill and bleed the new system with Wilwood Hi-Temp° 570 grade fluid or higher. For severe braking or

Page 7 - Pad and Rotor Bedding

Page 7Brake Testing• Make sure pedal is firm: Hold firm pressure on pedal for several minutes, it should remain in position without sinking. If pedal

Page 8 - Associated Components

DS-834A REV DATE: 05-17-13290-0632290-6209340-11295340-11299260-6089260-10500260-3374220-12092Wilwood Racing Brake Fluid (Hi-Temp° 570) (12 oz)Wilwoo

Comments to this Manuals

No comments

Wilwood Dynapro 6 Big Brake Front Brake Kit (Hat) User Manual

Browse online or download User Manual for For bicycles Wilwood Dynapro 6 Big Brake Front Brake Kit (Hat). Wilwood Dynapro 6 Big Brake Front Brake Kit (Hat) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For bicycles Wilwood Dynapro 6 Big Brake Front Brake Kit (Hat)